search

Mi-T-M Pressure Washer Manuel de l'opérateur Page 13

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 28
  • Table des matières
  • DEPANNAGE
    •
  • MARQUE LIVRES
    • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 12
Mi-T-M
HSE-SERIES Operator's Manual 13
BURNER FUEL TANK:
1. Review "Risk of Explosion or Fire" pg. 5, before fueling.
2. Locate the Safety Decals on your unit and heed their warnings.
3. Fill the burner fuel tank with good quality, clean No. 1 or No. 2 fuel oil/diesel
or kerosene. Do not use gasoline!
WARNING
RISK OF EXPLOSION OR FIRE!
ALWAYS STORE FUEL AWAY
FROM THE WASHER WHILE THE
UNIT IS RUNNING OR HOT.
DANGER
RISK OF FIRE!
-DO NOT SMOKE WHILE
FUELING!
-DO NOT FILL THE FUEL TANK
WHILE UNIT IS RUNNING OR
HOT. ALLOW UNIT TO COOL FOR
TWO MINUTES BEFORE
REFUELING.
-DO NOT FILL FUEL TANK TO
POINT OF OVERFLOWING.
ALLOW APPROXIMATELY 1/4"
OF TANK SPACE FOR FUEL
EXPANSION.
INSTALLATION & PREPARATION
POWER CORD CONNECTION CONT'D.:
5. b.
SINGLE PHASE:
If this pressure washer is not provided with a GFCI,
this pressure washer should only be connected to a receptacle that
is protected by a Ground Fault Circuit Interrupter (GFCI) to comply
with the National Electric Code (NFPA 70) and to provide additional
protection from the risk of electric shock.
c.
THREE PHASE:
These pressure washers are not provided with
GFCI protection.
6. EXTENSION CORDS:
Mi-T-M DOES NOT RECOMMEND THE USE OF
EXTENSION CORDS!
If use of an extension cord is unavoidable, it must
be plugged into a GFCI found in circuit boxes or protected receptacles.
When using an extension cord, consult a qualified electrician to determine
the proper wire gauge needed for the length of the extension cord.
SINGLE PHASE:
Use only 3-wire extension cords that have 3-prong
grounding-type plugs and 3-pole cord connectors that accept the plug
from the product.
THREE PHASE:
Use only 4 wire extension cords that have 4-prong
grounding type plugs and 4-pole cord connectors that accept the plug
from the product.
Use only extension cords that are intended for outdoor use. These
extension cords are identified by a marking "Acceptable for use with
outdoor appliances; store indoors while not in use." Use only extension
cords having an electrical rating not less than the rating of the product. Do
not use damaged extension cords. Examine extension cord before using
and replace if damaged. Do not abuse extension cord and do not yank on
any cord to disconnect. Keep cord away from heat and sharp edges.
Always connect and disconnect the extension cord from the receptacle
before connecting and disconnecting the product from the extension cord.
7. Ensure the area between the pressure washer cord and outlet is kept dry.
8. Insert the male plug into a grounded AC outlet. DO NOT use an adapter
OR remove the grounding plug!!
WARNING
RISK OF ELECTROCUTION!
TO REDUCE THE RISK OF
ELECTROCUTION, KEEP ALL
CONNECTIONS DRY AND OFF
THE GROUND. DO NOT TOUCH
PLUG WITH WET HANDS.
Vue de la page 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Commentaires sur ces manuels

Pas de commentaire
Produits connexes et manuels pour Pulvérisateur de peinture Mi-T-M Pressure Washer
Pulvérisateur de peinture Mi-T-M HG-SERIES Instructions d'exploitation     (96 pages)
Pulvérisateur de peinture Mi-T-M JP SERIES Manuel de l'opérateur   (23 pages)
Pulvérisateur de peinture Mi-T-M HSP-SERIES Manuel de l'opérateur   (24 pages)
  • Trail-master Glip UVI Group Sagittar Fixapart
  • Coby Jeux de haut-parleurs Apple Modules de mémoire ILuv Lecteurs DVD/Blu-Ray portables Husqvarna Aspirateurs I-mate Logiciel
  • Dell PowerVault DL2000 Olympus SP-350 Sony MHS-PM5
  • Siemens EH875SN27E Manuel de l'utilisateur Mitsubishi-electric Mitsubishi Split-Type Manuel de l'utilisateur Electrolux ESL7845RA Manuel de l'utilisateur Yamaha RX-V371 Manuel de l'utilisateur Electrolux EHG6341FOK Manuel de l'utilisateur